TECNOEKA Srl _____________________________________________________________ use and instruction manual
page 20 _________________________________________________________________________________________
4.
4.
4.
4.6
6
6
6
Cleaning the external casing
Cleaning the external casing
Cleaning the external casing
Cleaning the external casing
The external steel surfaces should be cleaned with a cloth soaked in warm soapy water or with
a drop of vinegar added, they should be rinsed well and dried with a soft cloth.
If you use specific cleaning products, they must correspond to the requirements for cleaning
given in the paragraph “General information” (paragraph 4.1).
You should also remember that the table the appliance stands on or the surrounding floor
should not be cleaned using corrosive acid products (for example muriatic acid), as the fumes
that are given off could attack and damage the external steel casing.
4.
4.
4.
4.7
7
7
7
Periods without use
Periods without use
Periods without use
Periods without use
If the appliance is not used for a long time, it is good practice to unplug it from the mains (at
the magnetothermal safety switch upstream from the appliance) and to turn off the water with
the cut-of cock on the main supply line. It should be carefully cleaned inside the cooking
chamber and outside, taking special care to remove any salt deposits which would cause
corrosion to the steel surfaces.
We also advise protecting the appliance with an oily base spray (e.g. Vaseline oil), which forms
an effective protective film on the surface of the steel.
A suitable covering would also protect the appliance from the dust.
5
5
5
5.... Ma
Ma
Ma
Maintenance
intenance
intenance
intenance
5.1
5.1
5.1
5.1 General information
General information
General information
General information
A periodic control (at least once a year) of the appliance aids to guarantee long life and correct
operations.
Any sort of maintenance work on the appliance must be done exclusively by technically
qualified operators who have been trained in the maintenance work on this appliance.
Before beginning any sort of maintenance work on the appliance, turn the power supply off (at
the magnetothermal safety switch upstream from the appliance) and let it cool down.
Access is gained to the inside components that could require maintenance work by removing
the left side of the appliance.
5.2
5.2
5.2
5.2 Changing the lighting lamp in the cooking chamber
Changing the lighting lamp in the cooking chamber
Changing the lighting lamp in the cooking chamber
Changing the lighting lamp in the cooking chamber
Electrically switch off the appliance; unscrew the protective glass cap with the corresponding
rings for airproofing; unscrew the lamp and replace it with another lamp suitable for high
temperatures (300°C), with the following characteristics:
-
Voltage
230/240 V
-
Power
15 W
-
Fitting
E 14
Refit the glass cap with the corresponding rings for airproofing and power up the appliance.
5.3
5.3
5.3
5.3 Changing the door seal
Changing the door seal
Changing the door seal
Changing the door seal
The door seal has a rigid profile with fixing tabs. The profile must be fitted into the guide on the
face of the cooking chamber.
To change the seal, remove the old one from the guide by pulling hard at the four corners.
Clean any dirt from the guide and introduce the new seal (to make this operation easier, we
advise dampening the seal profile with soapy water).
5.
5.
5.
5.4
4
4
4
Resetting the thermal breaker safety device
Resetting the thermal breaker safety device
Resetting the thermal breaker safety device
Resetting the thermal breaker safety device
This device is reached by removing the left side of the appliance and can be reset by pressing
the key right down (which is marked by a special adhesive label), which is inside the electric
components compartment.
