En
gli
sh
19
Chapter 2 Setup
●
Attaching the Camera to a Fixture (Arm/Stand)
The camera should be installed using an arm or stand.
Attention
• When installing, do so by carefully following the information in the User Manual about the arm or stand.
•
Check that the xture meets the following standards.
- Clearance between the screw holes: 100 mm x 100 mm
- Max. weight allowed: Strong enough to support the total weight including the camera and accessories such
as cables
-
The screw length must meet the following speci cation.
Camera's screw hole
Up to 30 mm deep
Fixture
Commercially available screw
•
Please follow the speci cations for the screw tightening torque.
If the tightening is not performed correctly, the attached part may be damaged, which may result in injury or
equipment damage.
Screw tightening torque
1.0 N·m to 1.4 N·m
Required tools
Phillips screwdriver (No. 2)
• Connect the cables after attaching an arm or stand.
•
The camera, arm, and stand are heavy. Dropping them may result in injury or equipment damage.
•
Periodically check the tightness of the screws. If not suf ciently tight, the monitor may detach from the arm,
which may result in injury or equipment damage.
1.
Fasten the attachment screws at the four screw holes on the bottom of the
camera to secure the attachment xture in place.
Attention
•
Please follow the speci cations for the screw tightening torque.
Screw tightening torque
1.0 N·m to 1.4 N·m
Required tools
Phillips screwdriver (No. 2)
Bottom of the Camera
Unit: mm
4 x M4 (MAX depth 30 mm)
100
25
10
0
9
Summary of Contents for CuratOR SC430-PTR
Page 59: ...English 59...
