18
Chapter 3 SelfCalibration
3-1. Setting targets
Set calibration targets for Advanced Mode. You can set targets by using ColorNavigator 7 or on the
monitor itself.
When using the monitor itself, set the following functions in the "Color" menu.
• "Color Mode"
Select "CAL".
• "Target Settings"
Set a calibration target for SelfCalibration.
3-2. Executing
SelfCalibration can be executed by setting a schedule or it can be executed regardless of a schedule.
You can set a schedule by using ColorNavigator 7 or on the monitor itself.
When executing SelfCalibration by setting a schedule on the monitor itself, the method to enable
SelfCalibration differs depending on the type of color mode (Standard Mode or Advanced Mode).
Attention
• If there is a change in the video signal from the external device during SelfCalibration (the signal disappears, a
signal is input during a no-signal state, or other), SelfCalibration is automatically canceled.
●
Executing regardless of a schedule
Manually execute SelfCalibration.
There are two methods for executing SelfCalibration, as follows.
• Execute from the "SelfCalibration" menu
In the "SelfCalibration" menu, select "Execute".
SelfCalibration is executed for all the color modes selected as "On" in "Settings" - "Mode Settings" of the
"SelfCalibration" menu.
• Executing from the "Color" menu
In "Color Mode" in the "Color" menu, select "CAL", and then select "Execute Calibration".
Execute SelfCalibration for the displayed color mode.
●
Executing by setting a schedule
Set the calibration schedule for SelfCalibration.
In "Settings" in the "SelfCalibration" menu, set the calibration schedule and monitor date and time for
SelfCalibration.
Attention
• If a scheduled SelfCalibration is automatically canceled, it is executed again when the monitor transitions to
the power saving mode an hour or more after cancellation or when the monitor is turned off using .
●
Activating SelfCalibration in Standard Mode
Execute SelfCalibration in Standard Mode.
In "Settings" in the "SelfCalibration" menu, set the following functions:
• "Mode Settings"
Set "Standard Mode" to "On".
