GB
- 20 -
If the battery pack still fails to charge, send
•
the charging unit
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and
fi
res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.4 Battery capacity indicator (Fig. 8)
Press the button for the battery capacity indicator
(Item A). The battery capacity indicator (Item B)
shows the charge status of the battery using 3
LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED blinks:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
6. Operation
Secure your workpiece. Make sure that the work-
piece is held securely by a clamping device or a
vise.
Switching the equipment ON/OFF
The equipment is turned on (I) and o
ff
(0) with
the ON/OFF switch (Fig. 3 / Item 3). However, the
equipment will only start running after the speed
control has been activated (see section 6.3).
Before switching o
ff
, lift the machine o
ff
the sur-
face to the worked.
6.1 Using as a polishing machine
Only use special waxing and polishing agents
suitable for the machine.
When using waxing and polishing agents,
observe the instructions issued by their ma-
nufacturer!
The hook-and-loop fastener enables easy chan-
ging of the polishing attachment.
CAUTION!
To prevent damage to the surfaces of the work-
pieces you wish to polish, make sure that you
observe the following instructions:
•
Wash the vehicle before polishing, and keep it
free of any foreign bodies.
•
Make sure that the polishing attachment
supplied is free of any foreign bodies when
being used.
•
Make sure that the polishing attachment is
always mounted precisely in the center of the
sanding/grinding disk.
•
Before you start the equipment, check to en-
sure that the attachments are securely fitted.
•
Never touch the area you wish to polish with
the edge of the sanding/grinding disk.
•
To polish, select the speed required for your
purposes using the speed controller (see
section 6.3). The optimum working speed de-
pends on the material to be worked and the
(polishing) agent used. If necessary, this can
be established by conducting practical tests.
•
The polishing machine must lie fully on the
surface to be polished.
•
Mask plastic parts, since these change color
when polished and can become unattractive
in appearance.
•
Only polish in the shade, and never polish hot
paint.
•
Polish corners and edges very carefully. The
paint layer is thinnest at corners and edges.
As a precaution, you can mask these and po-
lish them by hand.
Anl_CE_CP_18_180_Li_E_Solo_SPK13.indb 20
Anl_CE_CP_18_180_Li_E_Solo_SPK13.indb 20
11.04.2022 13:14:25
11.04.2022 13:14:25
