6 Setting
OneCurve
350
rpm
Fwd
Ncm
·
3.0
1
2
The parameters of “OneCurve” can also be
changed make it different from default setting, and
there will be 4 corners around the parameter (
A
○
1
E
A
)(
A
○
2
E
A
).
If want to change back to default setting, long
press
S
to entry preset program during standby
state, select “OneCurve” and press
●
to confirm, the default setting will be recalled,
and the 4 corners around will disappear.
If want to change back to M1 (or M2-M10), long
press
S
to entry preset program during standby
state, press
<
or
>
to select M1 (or M2-M10)
again, then press
●
to confirm
WARNING
Changing the default setting is not recommended
only if you are very sure it can be changed,
otherwise has risk of file broken.
6.4 Advanced setting
Ve rsi on s
E.1.1.008
During power off state, holding down press
S
then
press
●
to entry advanced setting, the version
number software will appear on the display screen.
E-connect S can update software very easy without
tools and software. Contact your distributor to update if
necessary.
NOTE
After updating, all of the setting parameters will be
covered.
Auto Power Off
10
M i n
Press
S
again, the “Auto Power Off” time can be
change, press
<
or
>
to adjust, then press
●
to confirm.
The “Auto Power Off” time can be set from 3-15
minutes.
Page 19 / 47
