Amphion User Guide
Page 19 of 26
Installation and Operation
Once an Amphion S14-H or S14-C has been properly configured, it is
connected to the LAN that has access to the Internet. Next the
Amphion is powered on by inserting the green power terminal
block. Then the following should occur:
•
The yellow Power LED will turn on and the S14 will boot up.
•
After boot is complete in 1-2 minutes, the green System LED
will flash on and off once per second.
•
For S14-H or S14-C, after up to 4 minutes the blue Tunnel
LEDs and the System LED will flash on and off, when the
secure encrypted tunnel has been created through the
Internet to ei
3
.
•
For S14-N, one blue Tunnel LED and the System LED will
alternately flash to indicate its connection to an S14-H.
Now the Amphion is operating normally and the service network
will function properly. An authorized user can create a remote
service session key in ei
3
and use the key to access the configured
machine devices through the secure encrypted tunnel. When the
equipment is accessed, it should be possible to ping each device in
the machine network that is configured in the S14-N, via each
device’s corresponding ei
3
Argo IP address. If you don’t know the
Argo IP address for your machine devices, contact your ei
3
administrator.
Note: An Amphion S14-N should not be connected to the internet
.
