EHEIM eXperience 350, Important Safety Instructions Manual

Page: 15 / 66

11
Examine all three o-rings on
the double tap connector for
damage and correct fitting
and lightly grease them with
Vaseline; insert and lock in
place.
After both of the tap levers
on the integrated double tap
connector have been open-
ed (position
ON ), the filter
will automatically fill up
again with water and will be
ready for operation.
Set the filter into operation
by connecting the mains
plug.
Press the first one down to the support frame and be sure
that the following media containers have a flush fit. In the
process, the pipe openings of the media containers must lie
on top of each other and the rubber seals must be correct-
ly fitted on the openings so as to achieve a hermetic seal.
Insert a new filter pad and cover it with the lattice screen.
ATTENTION: Fine filter pad (white) should not be placed
under the retractable handle of the media container.
Check to ensure that the sealing gasket of the pump head
fits properly and is clean.
Then lightly lubricate the sealing gasket of the pump head
with Vaseline. Place the pump head on the filter canister,
close the EZ clips and place the filter into the cabinet.
GB
For indoor use only. For use with aquariums. The aquarium filter is for domestic use only.
All electrical equipment in the water must be disconnected from the mains during care and maintenance work. It is imperative to disconnect the filter from the mains prior to
opening it.
The connecting line of this device can not be replaced. In case of damage to the power cord, the device is to be scrapped. Never carry the pump by the cable; do not bend the
cable.
This equipment is not intended for use by persons (including children) with limited physical, sensory or mental abilities or for persons with no experience or knowledge unless
they are supervised by a person responsible for safety or unless they have received from such a person instructions on how to use the equipment.
Children should be supervised to ensure that they do not play with the equipment.
Notice: These devices produce magnetic fields which might cause electronic and mechanical disturbances or damages. This also refers to pace-
makers. Please consult the manuals of medical equipment for the required safety margins.
Attention: Maintenance work presents the risk of crushing th fingers due to high magnetic forces.
For your own safety, we recommend to form a drip loop with the connection cable to prevent any water running along the cable from intruding into the
socket. When using a multiple socket or an external power supply unit, position them atop the filter’s power connection.
Since a wide variety of varnishes and polishes are used when processing timer, the appliance feet can leave visible traces on furniture or parquet floors
as a result of chemical reactions. Therefore the device should not be placed on unprotected wooden surfaces.
To achieve optimal operational safety there must be a maximum of 180 cm between the surface of the water and the bottom of the filter.
Attention: Filter must always be operated in an upright position only.
Burning danger! Be careful when touching the heating coil of devices with integrated heater.
Take the necessary precautions when handling components that can discharge static electricity.
Do not clean the unit – or parts of it – in the dishwater. Not dishwater resistant!
Do not dispose of this product as normal household waste. Take it to your local refuse collection side.
The product is qualified in accordance with the respective national regulations and guidelines and meets EC standards.
Safety instructions
20 cm
max.
180 cm