ExtraLab Plus – Cork Extraction Force and Torque Measuring System
16 / 59
Figure 9 – Values introduction
The keys are the control means available for
navigating between the different modes. These also
allow
to
command
individual
movements
(Calibration Mode) and to configure the equipment
(Configuration Mode). The keys have the following
functionalities:
•
Function Keys (
Figure 8/A
): These keys
command the equipment according to the function that appears on the lower edge of the
display.
•
Navigation Keys (
Figure 8/B
– lighter background): these keys assume distinct functions
depending on the mode. Further the keys
and
will be designated as “up” and
“down”. And the keys
and
will be designated as “right” and “left”.
•
Central Key (
Figure 8/C
): The role of this key will also depend on the active mode. On Test
Mode the function is for “OK” and the equipment will perform a test, or start the equipment
depending on the equipment status. On Calibration mode, it will be for raising the base for
bottle elevation and on configuration mode it will be used to confirm the selected option.
3.2.1.1. Template for values introduction
On the configuration menu there are some templates
for introducing values (
Figure 9
) which will be
validated by the range of values indicated on the
upper side of the screen. To select a value, browse
through the characters available and press the
central key to confirm the value. Repeat this
operation until the end of the introduction. To confirm
the value, press “RET” and to cancel the introduction,
press “ESC”. If the value that is being introduced is
out of the validation range, this introduction will not be
allowed.
Figure 8 - Keys of the console
A
B
C
