ExtraLab Plus – Cork Extraction Force and Torque Measuring System
50 / 59
- 1 Torsion set
- 1 centering bar / load
cell support bar
- 1 sheave / pulley bar
3.2. Setup (Opening direction)
3.2.1.
Unscrew the inferior screws of the back acrylic protection and push it slightly away.
3.2.2.
If not in place, apply the centering bar at the lower level entrance.
3.2.3.
Fix the torsion set “star” on the gripper holders. By hand rotate the gripper all the way in
the clockwise direction.
3.2.4.
Move the gripper using the up/down arrow keys in order to insert the centering pin, at the
lower part of the torsion, on the centering bar bearing. As the pin gets close to the
bearing, with one hand orientate the pin so it assumes the best position regarding the
bearing.
Annex C . Table 3 - 1
“Star”
90º
Parallel
Centering
Bearing
Pulley bar
positioning pins
Acrylic protection
Annex C . Figure 3-1
Pin
Arm
Back screw
