Cummins 6.7L CM2350B CSP5
User
Guide
- 18 -
www.efilive.com
2. Click on the Start button to begin the countdown timer.
3. DO NOT turn the vehicle ignition on until the countdown timer
expires. This time is critical to allow the ECM to perform internal functions
after a read operation.
Switch Tunes using FlashScan/AutoCal V3
1. Connect your FlashScan/AutoCal V3 device to your vehicle.
2. Turn the vehicle ignition to the
On
position
3. Navigate to the
Tune Tool
menu and select
F3 Switch Tunes -> F1 Switch
CSP5
menu option.
4. Use the arrows to navigate between tunes.
5. Press
✔
to make a tune selection.
6. If you attempt to select a tune higher than #4 you will see an error that indicates
the tune # is not supported. The ECM will ignore this request and keep the last
valid tune selected.
7. You do not need to reselect the tune once the engine is shut down; the ECM
'remembers' which tune you previously selected.
FlashScan V2
Data Logging
1. Configure FlashScan V2 for BBX features if not already setup.
2. Connect your FlashScan V2 device to your vehicle.
3. Turn the vehicle ignition to the
On
position
4. Navigate to the F1 Scan Tool - F1 Select PIDs menu option.
5. Select correct controller type from BBX configured controllers.
6. Navigate to the F1 Scan Tool - F2 Data Logging menu option.
7. Select F1: Record Data to commence the logging session.
8. Start the vehicle and drive to record actual performance.
9. Stop the vehicle and turn the ignition off prior to selecting Cancel on
FlashScan V2 to save the log file.
