
Document ID: OMM-00148 Rev. B
82
9.4 E-Stop Conditions
Emergency stops are installed at each end of the EFI Pro 24f printer. These should be used
only
when there is an
emergency condition. E-Stops should not be used to shut off the machine under normal conditions.
Figure 9-3: Typical E-Stop
9.4.1 Activating E-Stop
To activate an E-Stop, press any red E-Stop button (
Figure 9-3
). This shuts off power to all printer systems. Then do the
following:
1. Resolve E-Stop condition.
2. Move carriage to the “Home” position.
3. Shut off main breaker.
4. Reset all E-Stops. (To reset an E-Stop, press down and rotate the knob counter-clockwise. Release the downward pressure and let
the red knob spring up)
5. Turn main breaker back on.
9.4.2 Restarting After E-Stop
Perform the steps below to restart the printer after an E-Stop.
1. Ensure the condition that caused the emergency is resolved.
2. Manually return the carriage to the “Home” position if it is not there.
3. Reboot the computer and turn on the monitor.
4. Make sure the Printer Control Utility has restarted.
5. Check each E-Stop switch and release the knob if it is engaged.
6. Power on the printer main breaker.
7. Power on the system switch.
Warning:
Ensure that there is no one in the way of the printer mechanics.