3-13
3
Replacing Fiery X3e board components
Battery
The battery on the Fiery X3e board is located at BT200, near the DIMMs. To replace it,
use a 3V manganese dioxide lithium coin cell battery (Panasonic CR2032 or equivalent).
CAUTION:
There is danger of explosion if the battery is replaced with the incorrect type.
Replace only with the same type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer's instructions.
ACHTUNG:
Es besteht Explosionsgefahr, wenn die Batterie durch eine Batterie falschen Typs ersetzt wird. Als Ersatz dürfen
nur vom Hersteller empfohlene Batterien gleichen oder ähnlichen Typs verwendet werden. Verbrauchte Batterien müssen
entsprechend den Anweisungen des Herstellers entsorgt werden.
ATTENTION:
Il y a risque d'explosion si la pile est remplacée par un modèle qui ne convient pas. Remplacez-la uniquement par
le modèle recommandé par le constructeur. Débarrassez-vous des piles usées conformément aux instructions du constructeur.
ADVARSEL!:
Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering Udskiftning må kun ske med bat-teri af samme fabrikat
og type. Levér det brugte batteri tilbage til leverandøren.
VAROITUS:
Paristo voi räjähtää, los se on virheellisesti asennettu. Vaihda paristo ainoastaan laitevalmistajan suosittelemaan
tyyppiin. Hävitä Käytetty paristo valmistajan ohjeiden mukaisesti.
ADVARSEL:
Eksplosjonsfare ved feilaktig skifte av batteri. Benytt samme batteritype eller en tilsvarende type anbefalt av
apparatfabrikanten. Brukte batterier kasseres i henhold til fabrikantens instruksjoner.
VARNING:
Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ som rekommenderas av
apparat-tillverkaren. Kassera använt batteri enligt fabrikantens instruktion.
T
O
REPLACE
THE
BATTERY
1.
Locate the battery on the Fiery X3e (see Figure 3-4 on page 3-9).
2.
Carefully lift up the clip that holds the battery.
Use caution when lifting up the clip; excessive force could cause the clip to lose its
tension.
F
IGURE
3-7
Fiery X3e battery
3.
Pull the battery out of its socket and release the clip.
4.
To insert a new battery, slide the battery into the socket under the clip with the positive
(+) side facing up.
Make sure the clip holds the battery securely in the socket.
5.
Reassemble the Fiery X3e and verify functionality.
See “Restoring Fiery X3e functionality after service” on page 3-19.
The date and time of day are lost when the old battery is removed. See the Configuration
Guide for instructions on entering Server Setup to program the system date and time.
Clip
Battery
Socket
+
