3-12
3
Service Procedures
DIMMs
Each DIMM (dual in-line memory module) is held in place by levers at each end of its
socket on the Fiery X3e board. See Figure 3-1 on page 3-2. In the initial configuration,
DIMM slot J48 holds one 128MB DIMM and DIMM slot J49 is empty. Approved
DIMMs are available from your authorized service representative.
T
O
REPLACE
OR
UPGRADE
A
DIMM
1.
To release a DIMM, push outward on the lever on each side of the DIMM.
See the following figure.
F
IGURE
3-6
Releasing a DIMM
2.
Slide the DIMM out of the socket at the same angle as the socket and set it aside.
DIMMs of different memory capacity look alike, so take note where you place loose
DIMMs.
3.
To install a DIMM, slide it into the angled socket at the same angle as the socket. Push
the DIMM into the socket until the levers snap into place.
Make sure that the levers close securely around the ends of the DIMM and that the
DIMM is fully seated in its socket. Avoid flexing the board while you firmly seat the
DIMM in its socket. The DIMM fits the socket only one way. The two notches on the
bottom of the DIMM should line up with the notches in the socket.
4.
Reassemble the unit and verify functionality.
See “Restoring Fiery X3e functionality after service” on page 3-19.
To verify memory capacity, print a Configuration page to check the amount of memory
recorded under Server Info.
Lever
DIMM
Socket notches
Lever
