High power shape projector
USER’S GUIDE EFFI
-SHARP-V2
Version 2.1.2020
Last update:
June 17, 2020
Mini Parc du Verger
–
Bâtiment E
1 Rue de Terre Neuve
91940 LES ULIS, FRANCE
Tel: +33 9 72 38 17 80
Fax: +33 9 72 11 21 69
Email: [email protected]
Page 3 / 4
CONTACT ARRANGEMENT
–
PSV & FAN version
The EFFI-SHARP is supplied with a 24V constant voltage. The power consumption depends on the LED version (MX1 or MX2) and on the intensity
which flows through the LED. It is comprised between 45W and 90W.
CONVENTION CABLE M12
Pin
number
Cable color Contact arrangement Designation
Details
Max Power Consumption
(with MX2 LED version)
1
Brown
+24V
+24V
2,6A@24V (strobe)
1,65A@24V (continuous)
2
White
NPN
NPN [triggered on falling edge] -
Max 24V
(Light ON if V
NPN
< 1.5 V / OFF if
V
NPN
> 3V)
12mA@3,5V
3mA@5V
0,5mA@10V
0,15mA@24V
3
Blue
GND
GND
/
4
Black
PNP
PNP [triggered on rising edge] -
Max 24V
(Light ON if V
PNP
> 4.5 V / OFF if
V
PNP
< 3V)
12mA@24V
3mA@10V
0,5mA@5V
0,15mA@3,5V
5
Grey
AIC*
AIC (Analog Intensity control)* -
Max 24V
3mA@24V
(1
) If the AIC is not connected, the light will light on at 100% as if V
AIC
=24V. If you don’t need to adjust light level do not connect/use this PIN.
MODES CONTROL
MODE
DESCRIPTION
SCHEME
Auto-Strobe
mode
The LED driver inside the product is set to automatically
pulse the LED.
If you trigger light for a short pulse (< 100 µs), light is pulsed
(LED are driven at 2A).
If your pulse is longer, light automatically decreases LED
current to protect LED against failure.
To protect LED, the product will enter in protection mode
(Light is OFF for 2 second) if the duty cycle is superior to 0.3.
Every 2 seconds, the product will check if duty cycle is correct
to restart.
If D=Duty cycle (ON
TIME
/ (ON
TIME
+ OFF
TIME
)) > 0.3
→
Light shutdowns for 2 seconds
Continuous
mode
If you set trigger NPN (or PNP) continuously ON the light will
run continuously with a 700 mA LED current.
Analog
Intensity
Control (AIC)
By adjusting the analog voltage, light intensity can be
controlled from 10% to 100%. If the Input AIC is not
connected, the EFFI-SHARP will act as if AIC was set at 24V.
•
0
–
3V: LED OFF
•
3
–
10V: ≈1
0% to 100% light intensity
•
10 - 24V: LED ON 100%
•
100% if not connected
Electronical consideration
M12 male connector
