Advice for the Installer
IMPORTANT:
•
The cooktop is to be installed only by authorized person according to the current local
regulations and in observation of the manufacturer’s instructions.
•
Incorrect installation, for which the manufacturer accepts no responsibility, may cause
personal injury of damage.
•
Always disconnect the cooktop from mains power supply before carrying out any
maintenance operations or repairs
Product Dimensions
L(mm)
W(mm)
H(mm)
D(mm)
A(mm)
B(mm)
X(mm)
HB BI 2721 A
730
420
58
54
680
380
Min 50
Selection of Installation Equipment
•
The cooktop must be housed in heat-resistant work surface to avoid large deformation
caused by the heat radiation.
•
Cut the work surface according to the dimension shown in the above table (Fig.1)
•
A minimum of 50mm space shall be kept around the hole (refer to “X” in Fig.1)
•
Be sure the thickness of the work surface is at least 30mm.
•
The base of the cooktop must have direct unrestricted ventilation to the room where the
cooktop is installed. Follow the requirement of figure 2.
Under any circumstances, make sure the cooktop is well ventilated and the air inlet and
outlet are not blocked. Ensure the cooktop is in good work state.
Fig.1
INSTALLATION
