VS00E01KNXFI01010007.
DOC
Eelecta® Touch Panel 3,5 KNX – Product Handbook
134/156
Eelectron SpA, Via Magenta 77/22, I-20017 Rho (MI), Italia
+39 02.9316681 +39 02.93507688
[email protected] www.eelectron.com
VS00E01KNXFI01010007.doc
C.F. e P.IVA 11666760159
Capitale sociale: 250.000,00€ interamente versato
Tribunale di Milano 359157-8760-07
CCIAA Milano 148549
18.37. Stand-by setpoint temperature (absolute) (Temp. Contr. Settings)
See also article "Setpoint handling, Page 113“.
Stand-by setpoint for a heating or cooling controller, set as absolute temperature value.
18.38. Stand-By
setpoint
temperature
(heating, absolute) (Temp. Contr.
Settings)
See also article "Setpoint handling, Page 113“.
Stand-by setpoint for a combined heating/cooling controller, set as absolute temperature value for the heating controller
part. For the stand-by setpoint of the cooling controller part, the value set here is mirrored at the comfort setpoint .
(calculation: Stand-bySetpointCooling = ComfortSe (ComfortSetpoint - Stand-bySetpoint)).
18.39. Stand-by
setpoint
temperature de-/increase (Temp .Controller
Settings)
See also article "Setpoint handling, Page 113“.
Economy setpoint for a heating/cooling controller, set as temperature difference to the comfort setpoint (relative).
18.40. Stand-By
setpoint
temperature decrease (Temp. Controller
Settings)
See also article "Setpoint handling, Page 113“.
Stand-by setpoint for heating controller, set as temperature difference to the comfort setpoint (relative).
18.41. Standby
setpoint
temperature increase (Temp. Controller
Settings)
See also article "Setpoint handling, Page 113“.
Stand-by setpoint for cooling controller, set as temperature difference to the comfort setpoint (relative).
18.42. Steady-output value (Controller Page Fan)
Determines in which intervals the output on the object "Output, Fan Continuous [%]" is sent. See figure below.
If this is selected, the parameter option "Fan Steadyoutput Stepwidth [%]" (Controller Page Fan) is enabled. Now this
new parameter allows to set a stepwidth, which defines how much the object "Output, Fan Continuous [%]" has to
change until it is sent again.
The output is only sent if the value passes the corresponding limit of the limits set by the parameters "Controller Fan
Limit X [%]" (Controller Page Fan).