Eelectron Spa
IN00B02WEBFI00060140_KNX_MANUAL.DOCX
32/42
SETTINGS
Introduction
You can specify general KNX communication operation settings by accessing the
TECHNOLOGIES → KNX → CONFIGURE COMMUNICATION page
Physical address
with which HORIZONE SERVER communicates with the KNX bus, entering it in
the appropriate field; the address must be specified in the X.Y.Z form respecting the limits imposed
by the KNX protocol:
●
First number between 0 and 15
●
Second number between 0 and 15
●
Third number between 0 and 255
Unlike most KNX devices, which must necessarily have a physical address consistent with
that of the bus line in which they are installed, HORIZONE SERVER is able to communicate
with all devices in the system regardless of their address.
Changing the address of HORIZONE SERVER is, therefore, mainly intended to avoid any
conflicts with other devices and/or “order” within the KNX system.
It is also possible to determine whether HORIZONE SERVER should communicate with the KNX
system directly, through the integrated communication port, or via an IP KNXNet/IP router; choose
the desired method using the appropriate drop-down menu.
