Eelectron Spa
IN00B02WEBFI00060140_KNX_MANUAL.DOCX
20/42
KNX OBJECTS
Creating objects manually
As an alternative to the ETS import procedure described above, you can manually enter KNX objects
into the supervision. This method is useful when you need to make minor changes to your project; if
you need to create a large number of objects, you should always use the import procedure.
To manually enter one or more KNX objects, go to the
TECHNOLOGIES → KNX → ADD KNX OBJECTS page
Pressing the ADD button creates a new row in the list of KNX objects (initially empty), in which you
can specify:
NAME
Text label that identifies the new address in the project
W / R
Enable flags for write and read respectively
Specifies whether the new group address to be created should be
enabled in command and/or read.
COMMAND ADDRESS If the W flag is active, enter the group address for the command (towards
the KNX bus) in the 3-level format (X/Y/Z)
STATUS ADDRESS
If the R flag is active, enter the group address for reading from the KNX
bus in the 3-level format (X/Y/Z)
NOTE: this field is optional if the W flag is also active. In this case, it
means that the group address to be created must be used to send the
command, but also to read the status. (*)
LENGTH
Select the length, from those available, of the KNX telegram data for the
group address you want to create.
(*)
ENCODING
Depending on the
length
you choose, select the most suitable encoding
for the data sent or received on the group address you want to create.
(*)
FUNCTION
Choose a membership category for the objects you want to create, from
those available. Choosing the function also filters the list of available
renderings
RENDERING
Select a graphic to use to represent the objects you want to create within
supervision. The list of renderings depends on the encoding type chosen