Eelectron Spa
IN00B02WEBFI00060140_KNX_MANUAL.DOCX
19/42
This import mode is automatically activated when the project exceeds the address limits which can
be managed by the version of HORIZONE SERVER.
At the beginning of this section, the number of selected addresses (plus any previously imported
ones) and the limit set by the version of HORIZONE SERVER are indicated; by selecting one or
more addresses (or the entire group of addresses), the counter is recalculated, showing how many
addresses are still available at all times.
Once the selection of the objects has been completed, pressing the “NEXT” button starts the import
procedure; if it is completed correctly, the summary and any list of objects not covered by the ETS
rules is presented, as previously seen.
Not all the KNX addresses may be selected for a successful import since some of the selected
objects depend on other unselected addresses (e.g. multiple commands, status feedback, etc.). In
this case, a message is displayed as in the following example:
You can then:
●
Include all addresses automatically by clicking on the link at the bottom of the message
●
Manually include some of them by locating them in the list of addresses in the project
●
Enable ADVANCED access level and disable “CREATE AUTO-RELATIONS”
