Edwards PGC201, Instruction Manual

Page: 25 / 68

D0300040001EN - Installation
Page 15
Benchtop instrument
When intending to use the PGC201 as a benchtop instrument, then proceed as follows:

Push one of the two edge protection rubber pieces
supplied with the product
over the
top edge of the front panel (see Figure 4 item 1).

Place the PGC201 on its back (see Figure 4 item 2).

Push the second edge protection rubber piece
supplied with the product
onto the
bottom edge of the front panel.

Stick the two rubber feet
supplied with the product
onto the bottom of the housing.

Turn the PGC201 over again and move it to the desired place.
Figure 4 Preparing the instrument for utilisation as a benchtop unit
Connections
Rear side of the instrument
Figure 5 shows the rear panel of the PGC201. The way in which the individual connections
have been wired is described in the following sections.
WARNING:
When using the PGC201 as a benchtop instrument fit the two edge protection rubber
pieces onto the top and bottom edge of the front panel to avoid injury by sharp edges.
1. Top side
2. Bottom side