EDNord QMS magicolor, User Manual

Page: 224 / 446

7. Use clean, dry cotton cloths to gently wipe up any loose toner
from the OPC belt cartridge area in the printer.
8. Clean the charger unit by sliding the wire cleaner along the
groove in the top of the unit several times; then, flip the unit
over and run the wire cleaner several times across the grid
plate (a metal screen) on the bottom (fig. 6.13).
9. Turn the OPC belt cartridge up on the handle end again, and
place the charger unit back into its slot.
10. Swing the three brass latches back over the charger unit to
hold it in place.
11. Lift the OPC belt cartridge up and swing the green end-handle
open.
12. Holding the cartridge by its handle, slide it back into the
printer until it snaps in place. The cartridge is in place when
you can see the green arrows inside the metal frame of the
printer.
Fig. 6.13 Clean the Charger Unit
Chapter 6
6 - 3 0 C o n s u m a b l e s a n d P r e v e n t a t i v e M a i n t e n a n c e
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500