EDNord QMS 1060E, Getting Started

Page: 75 / 120

Configuring the
Interface
4-13 Connecting to an Ethernet Network
3 In the Administration/Communications/Network 2/CrownNet/
NetWare/RN Printer/Printer Slot # menu, enter the printer slot
number.
» Note: This number must match the slot number chosen in the
Printer Configuration submenu of the Print Server Configuration
menu in the NetWare PCONSOLE utility.
4 In the Administration/Communications/CrownNet/NetWare/
RN Printer/PServer Name[1], PServer Name[2], and PServer
Name[3] menus, enter the name of the print server.
» Note: The three PServer Name[x] menus allow you to identify 1
print server with a name up to 48 characters long. (Up to 16
characters can be entered in each of the three menus). You
cannot use these
three menus to identify three print servers.
Spaces and lowercase characters are not allowed. However,
underscore characters (_) are allowed to simulate multiword
names (for example, PUBS_PSERVER). At the printer control
panel only, a space must be used following the last character of
the print server name to end the name.
5 Reset the NIC by using the Administration/Communications/
Network 2/CrownNet/Common/Soft Reset menu.
6 Skip to “Configuring the Network,” later in this chapter.
TCP/IP
1 If necessary, in the Administration/Communications/Network
2/CrownNet/TCPIP/Internet Address menu, enter the
printer’s Internet address.
The factory default Internet address is 161.033.128.024.
2 If necessary, in the Administration/Communications/Network
2/CrownNet/TCPIP/Default Router menu enter the Internet
address of the default router.
The factory default router address is 000.000.000.000.
EDNord - Istedgade 37A - 9000 Aalborg - telfon 96333500