Page
8
Solution-8 Operators Manual
Electronics Design & Manufacturing
MA800O3C.DOC
Extinguish Mode
This option when programmed by your installer will cause the indicators on your
console to automatically extinguish if the console is not used for a period of sixty
seconds. At any time the indicators can be brought back to an illuminated state by
pressing a button, an alarm condition or when the system is in entry time. The indicators
will not illuminate if a silent alarm is triggered.
NOTE:
This option can only be programmed by your installer
.
Console Operations
Introduction
The following pages will describe how to use and interpret the many console functions
that are available on the
Solution-8
.
Most functions are performed using the master code.
Before attempting to enter any of the master code functions ensure that the system is in
the disarmed state and that there are no alarm memory indicators flashing. If this is not
the case the following will be required.
If the zone indicators are flashing fast at three pulses per second, key in your master
code followed by the AWAY button.
If the panel becomes armed, (ie. the AWAY indicator is illuminated) key in your code
followed by the AWAY button again. This will place the system back into the disarmed
state.
If the system is not disarmed, (ie. the AWAY or STAY indicators are illuminated) key
in your code followed by the AWAY button.
The factory default master code is
2580.
This code can be changed at any time therefore
if your system master code differs from the default, please substitute your existing
master code in the following examples.
This code allows you to change any users code and even the master code itself. It is also
the only code that allows the execution of special functions as detailed later in this
manual.
Codes can be up to six digits in length. This is dependent on the configuration set up by
you installer.
Provided
for
Download
by
www.bendigosecurity.com.au