Solution-8 Operators Manual
Page
5
MA800O3C.DOC
Electronics Design & Manufacturing
Basic System Operation
The overall purpose of your alarm system is to deter any would be intruder from
entering your premises.
Before leaving your home or office make sure all the windows and doors are closed.
Key in your designated code followed by the AWAY button. Your alarm system will
now arm and commence counting down the pre-programmed exit time.
You should exit the building during this time closing the exit path on your way.
After the exit time expires, a long beep will be heard and any unsealed zones will
automatically be isolated.
The system is now ready to accept alarms.
If a sealed zone is now opened, a number of pre-programmed events will occur.
Following is a typical sequence of events.
The alarm system will activate the audible devices such as sirens and trigger strobe and
the dialler. The dialler will then transmit all relevant alarm information via the
telephone line alerting the respective persons of the current state of events.
The siren timer will commence counting down as soon as an alarm occurs. When the
time expires the siren will be automatically turned off and placed into a ready state for
the next alarm.
Upon your return, the strobe light will be operating informing you that there has been an
alarm.
One or a number of zones will be flashing allowing you to identify the particular zone
that has caused the alarm condition.
The next time the alarm system is armed the indicators will be cleared automatically.
This is a very basic outline of the general system operation. As there are many features
available in the
Solution-8
, there could be numerous variations from the above
sequence.
These would be determined and explained by your installer.
Provided
for
Download
by
www.bendigosecurity.com.au