Edirol V-440HD, Owner'S Manual, Page: 58 / 92

58
Menu Parameters
* For more on menus, see p. 24.
Settings for the final output are made here.
About the Final Output Format
You can select from the following formats for use with the final output.
* The selectable component format changes as above depending on the setup for “1. System Frame Rate” under “13. System.”
* RGB units are [horizontal (pixels) x vertical (lines) / frame rate (Hertz)].
About the Final Output Fade Control
There are two final output fade modes (p. 23), which can be changed as needed.
[1-12. Output Fade Mode Settings and Function of Each Controller]
OUTPUT FADE Button Operational Mode
You can select operation mode of fade in/out using OUTPUT FADE button.
[1-14. OutputFade SW Motion Settings and Operation When the OUTPUT FADE Button is Pressed]
* For more on these parameters, refer to “Switching Buses with the AUTO Button (HD/RGB)” (p. 30).
1. HD/RGB Output
Parameters Explanation Values
1- 1. Output Format (1080i) Sw Video format assigned to OUTPUT FORMAT (1080i) button * Refer to “About the Final Output Format.”
1- 2. Output Format (720p) Sw Video format assigned to OUTPUT FORMAT (720p) button * Refer to “About the Final Output Format.”
1- 3. Output Format (RGB) Sw Video format assigned to OUTPUT FORMAT (RGB) button * Refer to “About the Final Output Format.”
1- 4. Output Format Sw Lock OUTPUT FORMAT button lock Off, On
1- 5. Zooming Final output scaling adjustment 80.0–120.0
1- 6. Bright Final output brightness adjustment -64– +64
1- 7. Contrast Final output contrast adjustment -64– +64
1- 8. Saturation Final output saturation adjustment -64– +64
1- 9. Red Final output red adjustment -64– +64
1- 10. Green Final output green adjustment -64– +64
1- 11. Blue Final output blue adjustment -64– +64
1- 12. Output Fade Mode Final output fade control adjustment Auto, Manual
* Refer to “About the Final Output Fade
Control”
1- 13. Output Fade Color Final output fade color setting Black, White
1- 14. Output Fade Sw Motion Selects the operation mode when OUTPUT FADE button is
pressed Change, Continue, Jump, Cancel
* Refer to “OUTPUT FADE Button
Operational Mode.”
1- 15. Test Pattern Select Selects the Test Pattern to output Off, 75% Color Bar, 100% Color Bar
1- 16. HD/RGB Reset Resets the above settings to the original factory settings —
Component RGB
[NTSC] [PAL] 1366x768/60 1024x768/60
1080/60i 1080i/50i 1366x768/75 800x600/75
720/60p 720/50p 1280x1024/60 800x600/60
480/60p 576/50p 1280x768/75 640x480/75
480/60i 576/50i 1280x768/60 640x480/60
1024x768/75
Auto Manual
OUTPUT FADE Button Fades in/out according to value set with TIME knob Indicates the fade status (no operation is executed,
even when button is pressed)
- Lights when fade is completed
- Flashes while fade is in progress
- Off when no fade is being performed
TIME Knob Sets Fade-in/Fade-out time for final output Controls fade-in/fade-out time
Mode When Pressed During Operation Pressed During Operation and Pressed Again
Change (Initial setting) Stops Returns in response to level
Continue Stops Continues in same direction as that before stopping
Jump Forces execution of the operation —
Cancel Cancels the operation and returns you to the previ-
ous step —