Edgewater Networks 158CS, Owner Assistance Manual

Page: 10 / 90

8
Engine Stop Switch
This device is designed to prevent the operator falling overboard while the engine remains
running. The engine stop switch lanyard should always be worn by the operator, while the boat is
in motion. Pulling the lanyard from the control will stop the engine. If the engine will not crank
properly, the lanyard may not be properly attached to the engine stop switch.
Do not use the engine stop switch to stop the boat unless it is an emergency as it may
impair your ability to quickly re-start the engine.
**NOTE** Each ignition key has a 3 digit number stamped on it. Please record this number
for future reference on the service information page in the front of this manual.
3/Propulsion System
3.1 General
Your new EdgeWater 158CS is designed to be powered by a single outboard motor. Most 2-cycle
outboards currently use an automatic system to mix the oil with the gasoline before the engine
uses it. On a 158CS equipped with a 2-cycle engine, the oil tank is maintained in the crankcase.
Make sure this tank always has a sufficient amount of the recommended 2-cycle oil for your
cruise, plus some reserve. 4-cycle engines require oil be maintained in the crankcase also.
Always check the crankcase oil level before each day’s run.
Always follow the manufacturer’s recommendations and use only the recommended oil
types.
Don’t attempt to service your outboard or any of its components unless you are
thoroughly familiar with its operation and dangers. Many of the moving part components
are exposed and can pose an extreme danger to anyone unfamiliar with their operation.
Always leave the servicing to a qualified technician.
Each manufacturer provides manuals designed to assist you in the proper operation and
maintenance of your new engine. Follow their guidance and schedules for proper operation of
your new engine. With a modern outboard there is little to do as long as proper maintenance is
performed, in accordance with the manufacturer’s recommendations. If the boat is to be kept in
saltwater for an extended period, electrolysis and marine growth can become a problem. When
leaving your boat in salt water overnight or for an extended period, tilt the engine as high out of
the water as possible. This will decrease the possibility of marine growth on the outside of the
engine, as well as reduce the potential of marine growth compromising the cooling water inlets in
the lower unit, which can cause overheating.
Do not paint your outboard’s lower unit with paints designed for boat hulls. Some can
cause severe damage to your engine. Check with your engine manufacturer to get their
recommendation.
Do not attempt control adjustments unless you are very familiar with their function, operation and
adjustment. Failure to properly adjust the system components can adversely affect your boat’s