Edgetech 8242XS, Hardware Manual

Page: 14 / 82

xiv
8242XS Release 0004815_REV_G
LIST OF FIGURES
Figure 1-1: An 8242XS Release in the Arctic Sea ....................................................................................... 1-1
Figure 2-1: PCB Connectors ....................................................................................................................... 2-1
Figure 2-2: ICD 8272-XS Short – 0010816 .................................................................................................. 2-4
Figure 2-3: ICD 8242XS Long – 0011329 ................................................................................................... 2-5
Figure 4-1: The Purge Port Plug ................................................................................................................. 4-1
Figure 4-2: Remove the Purge Port Plug Retainer ..................................................................................... 4-2
Figure 4-3: Removing the Purge Port Plug ................................................................................................. 4-2
Figure 4-4: Removing the (3) Top Nut from the (3) Titanium Bolts ........................................................... 4-3
Figure 4-5: Using a Wrench to Pry the Cage Apart .................................................................................... 4-4
Figure 4-6: Tapping the Cage Free with a Mallet ....................................................................................... 4-4
Figure 4-7: Removing the Transducer End Cap .......................................................................................... 4-5
Figure 4-8: The Removed Transducer End Cap .......................................................................................... 4-5
Figure 4-9: Battery Connection Location and One Method for Plugging in the Board .............................. 4-6
Figure 4-10: The Proper Orientation of the Battery Pin Connector and JP5 ............................................. 4-6
Figure 4-11: Apply Pressure to the Base of the Transducer End to Fully Seat it into the Housing ............ 4-7
Figure 4-12: Cage Assembly for Transducer End Cap ................................................................................ 4-8
Figure 4-13: Attach One Part of the Lifting Support .................................................................................. 4-8
Figure 4-14: Applying the Second Part of the Lifting Support, Including the ½” Spreader Rods ............... 4-9
Figure 4-15: Use the Mallet to Ensure the Lifting Support is Securely Attached .................................... 4-10
Figure 4-16: Replace the Two Titanium bolts .......................................................................................... 4-10
Figure 4-17: Using the Wrench on the top bolt, at the bottom, tighten the first nut. ............................ 4-11
Figure 4-18: Top End Cap Completed Assembly ...................................................................................... 4-11
Figure 4-19: Replace the Purge Port Plug ................................................................................................ 4-12
Figure 4-20: The Replaced Purge Port Plug Retainer ............................................................................... 4-12
Figure 4-21: Clevis Rotation Drawing ....................................................................................................... 4-14
Figure 4-22: The Armed 8242XS .............................................................................................................. 4-15
Figure 4-23: The Release Link Captured by the Release Hook ................................................................. 4-16
Figure 4-24: Capture the End of The Hook onto the Latch Recess .......................................................... 4-16
Figure 4-25: Rotating the Shaft Using the Arming Wrench ..................................................................... 4-17
Figure 4-26: The Armed T-Shaft ............................................................................................................... 4-18
Figure 4-27: The Two Possible On/Off Actuator Plug Positions ............................................................... 4-19