EDGE30 / EDGE2440 / EDGE40 / EDGE2460 / EDGE60 / EDGE3860
Installation and Operating Manual
Original Instruction Manual
14
Rev 2.1 July 12, 2016
4. Lift the conveyor from both ends and slide it through the bake chamber slightly past
its control side stops. This allows room to attach the conveyor drive chain over the
drive sprocket. (Figure 14)
Figure 14
5. Install the drive chain over the conveyor drive sprocket. Pull the conveyor back out of
the control side of the bake chamber until the locking rails on each end of the
conveyor lock into place. This also locks the drive chain onto the conveyor drive
sprocket.
6. The conveyor drive chain is adjusted at the factory prior to shipment. To tighten the
drive chain (if required), loosen the four (4) bolts securing the conveyor drive motor to
the side of the control can, slide the drive-end sprocket towards the bake chamber to
increase the chain tension, then retighten the four (4) bolts to lock the motor in
position.
7. Slide the chain guard cover down between the control can and the drive belt frame
and onto its guide pins. (Figure 15)
