4
EDGE -
Item code: BH69
.
Instruction Manual
C/A glue
C/A glue
3) Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
Remove
covering
2. Using a modeling knife, remove the cov-
ering servo tray.
4. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into ai-
leron servo tray as same as picture below.
Aileron
Bottom side
C/A glue
C/A glue
Electric wire
Thread
