7
EDGE -
Item code: BH69
.
Instruction Manual
Repeat the procedure for the other wing
half
.
INSTALLING THE ENGINE MOUNT.
See pictures below:
INSTALLING THE STOPPER ASSEMBLY
FUEL TANK.
4 x 30mm
4 x 30mm
1. The stopper has been pre-assembled at
the factory.
2. Using a modeling knife, cut one length of
silicon fuel line (the length of silicon fuel line is
calculated by how the weighted clunk should
rest about 8mm away from the rear of the tank
and move freely inside the tank). Connect one
end of the line to the weighted clunk and the
other end to the nylon pick up tube in the stop-
per.
3. Carefully bend the second nylon tube up
at a 45 degree angle (using a cigarette lighter).
This tube will be the vent tube to the muffler.
Drill a hole 4mm
diameter
Silicon tube not included
