WARNING When installing the EGT (Exhaust Gas Temperature)
Thermocouple, wear eye protection and protective clothing to protect
from getting metal chips in your eyes. Also, since exhaust manifolds
can be very hot, allow the engine to cool before drilling. When work-
ing under the vehicle, make sure the park brake is set.
Supplied Items Qty
1 EGT Probe..........................(1)
2 Shrink Tube.........................(2)
Required Tools
- Electric/Cordless Drill
- 1/8” drill bit or similar size (for pilot hole)
- 21/64” (best size) or 5/16” drill bit
(for final hole)
- 9/16” wrench or socket
- 5/8” open end wrench
- 1/8”-27 NPT Thread Tap
- Phillips screwdriver
- 5/16” or 8mm wrench
CAUTION: One effective way to avoid metal fragment contamination
in your engine manifold is to apply grease in the tip of the drill bit and
threads of your tap tool when drilling/tapping the hole in your mani-
fold. Reduce pressure on the drill when the drill breaks through the
manifold wall to reduce risk of pushing metal chips into the manifold.
1. Obtain a 1/8”-27 NPT Thread Tap.
2. Drill a 21/64” (5/16” optional) hole through the manifold wall.
3. Use the pipe tap to cut the threads in accordance to the pipe
tap manufacturer’s instructions and recommendations.
Tapping and Probe Installation
Supplied Items & Required Tools
EGT Probe Installation
2
1
Summary of Contents for Juice Attitude
Page 1: ...ty...
Page 24: ...MAP Sensor PCM Suggested Juice Module Locations 2003 2007...