Edge Ovens EDGE40, Installation & Operating Manual

Page: 25 / 48

EDGE40 / EDGE60 Installation and Operating Manual
21 Rev 1.1 December 04, 2008
Figure 21
5. Install the drive chain over the conveyor drive sprocket. Pull the conveyor back out
of the control side of the bake chamber until the locking rails on each end of the
conveyor lock into place. This also locks the drive chain onto the conveyor drive
sprocket.
6. The conveyor drive chain is adjusted at the factory prior to shipment. To tighten the
drive chain (if required), loosen the four (4) bolts securing the conveyor drive motor
to the side of the control can, slide the drive-end sprocket towards the bake chamber
to increase the chain tension, then retighten the four (4) bolts to lock the motor in
position.
7. Slide the chain guard cover down between the control can and the drive belt frame
and onto its guide pins.(Figure 22)
Figure 22