Edge Ovens EDGE40, Installation & Operating Manual

Page: 13 / 48

EDGE40 / EDGE60 Installation and Operating Manual
9 Rev 1.1 December 04, 2008
Figure 4
4. Set the oven base assembly flat on its casters near the final installation area.
5. Tilt the oven assembly over so that the oven bottom is sitting flat on the floor. If
using a Genie SLA type lift, support the oven about seven inches above the floor
using cribbing blocks on all four corners to allow clearance for the Genie
base.(Figure 5)
Figure 5
6. Lift and place the oven onto the base using a Genie SLA or similar type of lifting
device.(Figure 6)