Edge-Core ES4612, Management Manual, Page: 564 / 666

Command Line Interface
4-250
4
Default Setting
Update: 30 seconds
Timeout: 180 seconds
Garbage collection: 120 seconds
Command Usage
• The update timer sets the rate at which updates are sent. This is the
fundamental timer used to control all basic RIP processes.
• The timeout timer is the time after which there have been no update
messages that a route is declared dead. The route is marked inaccessible
(i.e., the metric set to infinite) and advertised as unreachable. However,
packets are still forwarded on this route.
• After the timeout interval expires, the router waits for an interval specified by
the garbage-collection timer before removing this entry from the routing table.
This timer allows neighbors to become aware of an invalid route prior to
purging it.
• Setting the update timer to a short interval can cause the router to spend an
excessive amount of time processing updates.
• These timers must be set to the same values for all routers in the network.
Example
This example sets the update timer to 40 seconds. The timeout timer is
subsequently set to 240 seconds, and the garbage-collection timer to 160 seconds.
network
This command specifies the network interfaces that will be included in the RIP
routing process. Use the
no form to remove an entry.
Syntax
[ no ] network subnet-address
subnet-address – IP address of a network directly connected to this router.
Command Mode
Router Configuration
Default Setting
No networks are specified.
Console(config-router)#timers basic 15
Console(config-router)#