
System Management Commands
4-47
4
logging trap
This command enables the logging of system messages to a remote server, or
limits the syslog messages saved to a remote server based on severity. Use this
command without a specified level to enable remote logging. Use the
no
form to
disable remote logging.
Syntax
logging trap
[
level
]
no logging trap
level
- One of the level arguments listed below. Messages sent include the
selected level up through level 0. (Refer to the table on page 4-45.)
Default Setting
Disabled
Level 3 - 0
Command Mode
Global Configuration
Command Usage
• Using this command with a specified level enables remote logging and sets
the minimum severity level to be saved.
• Using this command without a specified level also enables remote logging, but
restores the minimum severity level to the default.
Example
clear logging
This command clears messages from the log buffer.
Syntax
clear logging
[
flash
|
ram
]
•
flash
- Event history stored in flash memory (i.e., permanent memory).
•
ram
- Event history stored in temporary RAM (i.e., memory flushed on
power reset).
Default Setting
Flash and RAM
Command Mode
Privileged Exec
Example
Console(config)#logging trap 4
Console(config)#
Console#clear logging
Console#
Summary of Contents for ES4612
