Edge-Core ES4612, Management Manual, Page: 408 / 666

Command Line Interface
4-94
4
Command Usage
• A mask can only be used by all ingress ACLs or all egress ACLs.
• The precedence of the ACL rules applied to a packet is not determined by
order of the rules, but instead by the order of the masks; i.e., the first mask
that matches a rule will determine the rule that is applied to a packet.
• You must configure a mask for an ACL rule before you can bind it to a port or
set the queue or frame priorities associated with the rule.
Example
Related Commands
mask (IP ACL) (4-94)
ip access-group (4-98)
mask (IP ACL)
This command defines a mask for IP ACLs. This mask defines the fields to check in
the IP header. Use the
no form to remove a mask.
Syntax
[ no ] mask [ protocol ]
{ any | host | source-bitmask }
{ any | host | destination-bitmask }
[ precedence ] [ tos ] [ dscp ]
[ source-port [ port-bitmask ]] [ destination-port [ port-bitmask] ]
[ control-flag [ flag-bitmask ]]
• protocol – Check the protocol field.
• any – Any address will be matched.
• host – The address must be for a host device, not a subnetwork.
• source-bitmask – Source address of rule must match this bitmask.
• destination-bitmask – Destination address of rule must match this bitmask.
• precedence – Check the IP precedence field.
• tos – Check the TOS field.
• dscp – Check the DSCP field.
• source-port – Check the protocol source port field.
• destination-port – Check the protocol destination port field.
• port-bitmask – Protocol port of rule must match this bitmask.
(Range: 0-65535)
• control-flag – Check the field for control flags.
• flag-bitmask – Control flags of rule must match this bitmask. (Range: 0-63)
Default Setting
None
Console(config)#access-list ip mask-precedence in
Console(config-ip-mask-acl)#