43
Eder Forestrytools
310003_04 | 06.2019
Fig. 23:
Starting system
>
Using a screwdriver, remove the small spring (
1
), the
washer (
3
) and the ratchet (
4
), then pull out the drum (
2
).
>
Remove the starter cord by unwinding it from the drum and
undoing the knot.
>
Insert the new starter cord (
5
) (Ø 3.5 x 960 mm).
>
Attach the starter cord to the drum with a simple knot (
2
).
>
Pull the starter cord through the housing (
9
) and the engine
starter handle (
6
) and then make a knot as shown in the
figure.
>
Insert the starter cord into the notch in the washer (
3
) and
turn it 7 turns clockwise.
>
Loosen the starter cord slowly. The starter cord is wound all
the way around the pulley with the help of the previously
wound spring.
>
Check that the spring is sufficiently wound. The engine
starter handle must be well tightened.
If the engine starter handle is loose:
>
Wind up the spring by turning the washer a few turns.
When the starter cord is fully wound up:
>
Turn the pulley half a turn clockwise or block the drum and
wind up the starter cord one turn.