310003_04 | 06.2019
Eder Forestrytools
30
EN
Fig. 12:
Cutting depths on the knife gauge
The smaller the knife protrusion, the less wood is removed and the
smoother the surface becomes.
> Loosen the knife screw (
1
).
> Push the knife (
2
) all the way back.
> Place the knife gauge (
3
) on the cylinder (
4
) so that it rests on the
two bearing surfaces of the cylinder at the top and bottom.
> Push the knife onto the knife gauge until the desired setting
height (0.2 mm, 0.4 mm, 0.6 mm) is reached.
> Retighten the knife screw. Tightening torque: 35 Nm.
EDER Trough Cutter Set ETH-A56
Sharp knives are required for optimal work with the EDER Trough
Cutter Set ETH-A56.
Blunt circular knives can be turned by 180° around the knife
screw and used again. The circular knives can be
resharpened. The rounding radius of the circular knives
must be maintained for good work efficiency.
i
Fig. 13
Knife adjustment
1
2
4
3
i