17
Eder Forestrytools
310003_04 | 06.2019
Fig. 4:
Mounting the support and the V-belt
> Place the support (
1
) with the slot between the two threaded pins
(
2
).
> Place the V-belt between the V-belt pulley and the clutch drum.
Fig. 5:
Fastening the peeling head to the support
> Make sure that the belt is already slightly pretensioned. If not,
loosen the Allen screw (
1
) (see Fig. 5) and push the peeling head
forward on the support until the belt is pretensioned.
> Replace the V-belt cover so that the pin in the cover (
3
) engages
in the support (
1
) (see Fig. 4).
> Tighten the V-belt by turning the V-belt tightening screw (
2
)
clockwise (see Fig. 6).