25
Eder Forestrytools
310003_04 | 06.2019
Operation
WARNING
Risk of injury due to unsafe standing position!
There is a risk of injury if your standing position is not stable or if
you work overhead.
> Always take a safe and stable position.
> Never work on icy or wet surfaces, as there is a risk of slipping.
> Never work on ladders or in unstable positions.
> While working, hold the device firmly with both hands so that no
parts of the body can approach the V-belt, the tool head or the
exhaust pipe. Grasp firmly the throttle handle with your right
hand and the front handle with your left hand. This also applies
to left-handed persons.
> Do not hold the device above your head when working and
always use both hands when working.
> Work calmly and carefully with good visibility and adequate
lighting.
Risk of injury!
If you do not observe the following points, injuries are possible due
to rebounding of the device.
> Only work on wood with the device (except for the Wire Brush
ERB).
> During work, make sure that the cutter head does not touch any
foreign objects (stones, glass, metal objects, etc.) that could
damage the cutter head or the V-belt.
> When the engine is running, place the cutter head or wire brush
on the trunk surface only at operating speed.
> Make sure that the throttle trigger is not blocked by the throttle
lock when working with the device, as in this case it is not
possible to control the rotation.
> Check that the knives are firmly seated before each use.
> Switch off the device before putting it down.
