310003_04 | 06.2019
Eder Forestrytools
22
EN
> Pull the front hand guard (Fig.7 no.
1
) to the rear to disengage
(release) the V-belt brake.
The release noise of the V-belt brake is clearly audible.
> Push down the pressure relief valve push-button (Fig.7 no.
2
).
> When the engine is cold: Set the stop switch (
6
) to
A
(cold start).
> With the engine warmed up: Set the stop switch (
6
) to the central
position
B
(operation).
> Hold down the throttle trigger lockout lever (
3
).
> Then pull the throttle trigger (
5
) and release it again.
> The throttle trigger is now engaged.
> Press the primer (
4
) 5 or 6 times.
Starting the engine
> Insert your foot into the throttle handle (p.8 Fig.1 no.5)
> Pull the engine starter handle (Fig.7 no.
7
) slowly until you feel a
little resistance.
> Now pull the engine starter handle quickly and firmly.
> Relax the cable and allow it to be rewound in a controlled manner
by continuing to hold the engine starter handle in your hand.
> Continue doing this until the engine makes a few starting noises.
The engine is now running idle.
When the engine is running
If the engine has already been started:
> Press the throttle trigger (Fig.7 no.
5
) and release it again
immediately.
The throttle trigger lockout lever is released and the engine
automatically regulates itself to the minimum speed.