8
Electrical connection
The appliance's electrical connection should always be carried out by an AUTHORISED TECHNICIAN.
The legal standards in force in each country on connections to the mains should be taken into account.
Check that the mains voltage corresponds to that indicated on the name plate.
Use cable sleeves made out of polychloroprene or other similar materials (H05RN-F), for the connection).
Put an autonomous power switch with fuses into the mains socket, with a minimum distance between contacts
of at least 3 mm.
It is obligatory to earth the appliance. The manufacturer will not be held liable for damage originated by failure
to observe this requirement.
The section of cable sleeve and the rating of the fuses to be installed in the power switch are indicated in the
table No. 2.
Route the cable through the stuffing box indicated in point E (Fig. 1) and connect it to the terminal strip.
When several appliances are installed in series, they should be earthed to each other using the point assigned
for this purpose, located in the rear part of the appliance.
2.- USE
Turning the appliance on
IMPORTANT: Never start up the appliance without having previously filled the tub; otherwise overheating
would seriously damage the machine.
Do not use more water than the maximum recommended amount.
It is recommended to insert the loaded basket in the water slowly so that the oil froth resulting from frying does
not boil over the upper part of the tub.
3.- MAINTENANCE
Initial cleaning
After installing the appliance, and before filling the tub with water, it is necessary to fill it with soapy water,
which should be left to boil for a few minutes. Next, empty the tub and rinse it as many times as necessary,
to eliminate the remains of soap.
Daily cleaning
In order for the appliance to work as new, it is advisable to follow the following instructions:
Do not use gritty and abrasive detergents for cleaning.
Do not use a water hose to clean the appliance.
It is advisable to regularly clean the inner part of the tub with soapy water that will be left to boil for a few
minutes, and then rinse it with plenty of water.
It is important that as soon as the tub has been cleaned and before filling it with oil, it be completely dry without
a sign of water.
IMPORTANT NOTE:
The replacement of any functional component that can affect the safety of the appliance must be carried out
by an AUTHORISED TECHNICIAN.
As a general rule, whenever an operating component is replaced, you must check that the mains tap is shut
and that is no fire in the vicinity of the appliance.
