ECTACO SpeechGuard™ TL-4
User Manual
21
Use the Stylus
Tap the screen with the supplied pointing device called the stylus,
which, when not in use, is conveniently kept in a special slot at the
side of the device’s back panel (see page 5).
The stylus cap screws off for your convenience to use it as a reset
pin.
♦
Note:
If, for some reason, using the stylus does not provide the
desired effect, you may need to perform touch screen
Calibration
.
Perform Calibration
This screen fine-tuning procedure will help you adjust the device to
comply with stylus commands.
1.
Go to the
Setup
section by pressing the
Setup
button, or just tap
on the word
MENU
in the upper part of the screen and then select
Settings
in the appeared menu.
2.
Tap
or press the
Left
/
Right
buttons to open the
System
Settings
screen.
3.
Tap
Calibration
or just press the
Setup
button. You will see the
calibration screen with five targets, appearing one after another as
you tap them with the stylus.
4.
To complete
Calibration
, please follow the instructions on the
screen. To skip
Calibration
, just press the
Recognize
button.
Tweak the System – Auto-off, Contrast,
Backlight
Your speech-to-speech translator has a number of features
designed to help you customize the interface. The following
sections will show you how to change the
screen contrast
, adjust
the
auto-off time
, and change the
screen backlight mode
.
1.
Go to the
Setup
section by pressing the
Setup
button, or just tap
on the word
MENU
in the upper part of the screen and then select
Settings
in the appeared menu.
