ENGLISH
Burner Assembly - Propane
10. Ensure you have assembled the control panel, as outlined
on page 10.
GAS INPUT
THERMOCOUPLE
INPUT
BURNER OUTPUT
11. Using two adjustable wrenches, attach the flexible propane gas
line to the inlet valve fitting (arrow pointing in). Do not overtighten.
11.Using two adjustable wrenches, attach the flexible propane gas line to the inlet valve fitting (arrow pointing in). Do not overtighten.
12. Using two adjustable wrenches, attach the flexible gas line
from the burner to the outlet valve fitting (arrow pointing out).
Do not overtighten.
12.Using two adjustable wrenches, attach the flexible gas line from the burner to the outlet valve fitting (arrow pointing out). Do not overtighten.
13. Connect the thermocouple to the control valve. Hand-tighten first
then securely tighten (1/2 turn) with a 10mm wrench. Damage to the
thermocouple and/or loose connections will cause operation issues.
13.Connect the thermocouple to the control valve. Hand-tighten first then securely tighten (1/2 turn) with a 10mm wrench.
Damage to the thermocouple and/or loose connections will cause operation issues.
14. Plug the Ignitor wire and grounding wire into the back side of the
sparker. These wires can be plugged into either port on the back side of
the sparker box.
14.Plug the Ignitor wire and grounding wire into the back side of the sparker. These wires can be plugged into either port on the backside of the sparker box.
15. Insert the fully assembled Control Panel into the side of the Surround
Unit, feeding the cables and wires back into the unit as needed until the
Control Panel is properly positioned in place.
15.Insert the fully assembled Control Panel plate into the side of the Surround Unit, feeding the
cables and wires back into the unit as needed until the Control Panel is properly positioned in place.
16.Secure the control panel assembly with the 4 screws. (Install the four black plastic screw caps on
the screw heads)
16. Secure the control panel assembly with the 4 screws. (Install the four
black plastic screw caps on the screw heads)
17. Install the glass screens.
17.Install the glass screens
18. Spread the glass media evenly over the burner surface. Use all black
glass media provided for best effect. Glass media CANNOT be present
inside the igniter wind guard. Remove the cardboard cover from inside
ignition wind guard.
Summary of Contents for ESF.2.B.G16
Page 27: ......
