10
11
11
10
9
8
7
7. To remove the RCI
™
Target,
grasp the frame and gently
pull screen out of unit.
9. Loosen two (2) screws
holding the plate cage. Slide
the cage forward, lift and
remove.
10. Rotate starter and lift
to remove.
11. Rotate UV Bulb 1/4 turn,
lift out of holders, and
remove from unit.
8. Disconnect the two (2)
lead wires attached to
the purifier plate cage.
REMOVING THE PURIFIER PLATE & RCI
™
TARGET
REMOVING THE UV BULB AND STARTER
TIP:
Hot water and ammonia work well to clean your
Purification Plates. Ask your EcoQuest Dealer for
more information. (See page 8 for complete cleaning
instructions.)
6
6. To remove the purification
plate, grasp edge of plate in
the center and gently pull out.
NOTE: If the plate is difficult to
remove, gently press down on
the lower metal contact tab.
5
4
3
1
2
REMOVING THE LINT SCREEN
1. Unplug unit.
2. Remove the two (2)
back cover screws.
3. Remove back cover.
4. Remove two (2) screws securing
the top of the lint screen holder.
WARNING: DO NOT OPERATE Fresh Air by EcoQuest
without the lint screen and back cover properly installed.
5. Remove the top of the lint
screen holder and the lint
screen together by pulling
back and lifting up and out.
To remove the
purification plate,
continue to step 6.
For installation of
the lint screen or
EcoHelp filter, go to
page 13.
To Remove:
Lint Screen
follow steps 1 - 5
Purifier Plate
follow steps 1 - 6
RCI
™
Target
follow steps 1 - 7
UV Bulb
follow steps 1 - 10
