INSTALLER
Hold the sub-base with one hand, press the case as shown
below and pull the bottom of the thermostat from the sub-base.
Press here to release
case from sub-base.
The thermostat can be installed on any interior wall
approximately 5 feet above the floor. To insure accurate
reading of the space temperature, the thermostat should not be
in direct sunlight.
Install the subbase using
two #8 or #6 sheet metal
screws with wall anchors
where required. Level the
thermostat for appearance.
1
1
2) Installing the Subbase
1
1) Remove the Subbase Before Installation
Slide the battery cover off and
install two AA lithium or alkaline
batteries. Install the batteries
with the positive terminals to
the right as shown. Replace
the battery cover.
3) Installing the Batteries
Option
Description
Zone number
Range
Range
Range
Range
Range
Range
Range
Range
Range
Range
1 to 8
1 to 8
1 to 5 F
o
60 to 90 F
o
55 to 80 F
o
0 to 100%
0 to 100%
0- 8%/F 1-16%/F
5 to 30 minutes
0- On with key
Default
1
1
1 F
o
80 F
o
65 F
o
50%
50%
0- 8%/F
10 minutes
On with key stroke
Home Address number
Dead-band Differential
Update interval
LCD back-light control
High setpoint limit
Low setpoint limit
Damper factor
Night airflow
Off airflow
01
02
03
04
05
06
07
08
09
10
INSTALLER OPTIONS
i
Ensure that the installation process does not alter the
damper in a way that will cause interference to the blade
moving freely.
CAUTIONS
Use cautions when mounting components to surfaces
that may have concealed wiring beneath the surface.
!
Read and follow all instructions carefully.
Follow all local electrical codes during installation. All
wiring must conform to local and national electrical
codes.
Read entire manual before installing products.
Caution! Direct Damper Controls are not an
alternative to zoning. Installing too many controls on
a single HVAC system could cause airflow and
pressure problems.
5
