12
Pressing the softener’s RIGHT (
4
) button manually
advances to the next screen in the sequence. Pressing
the LEFT (
3
) button manually returns to the previous
status screen. If no buttons are pressed for 30 sec-
onds, the automatic rolling sequence resumes.
FIG. 20
*
Water remaining before the next recharge.
NORMAL OPERATION
SOFTENER STATUS SCREENS
During normal operation, the water softener’s display
shows up to four status screens. Page 18 explains how
individual screens can be turned on or off. Each is
shown for six seconds, in a rolling sequence (See
Figure 20).
0.0 GPM
Water flow
2:34 PM
Salt status (NaCl)
2:34 PM
Water use (gallons)
2:34 PM
Out of salt in
119 days
Recharge status
2:34 PM
Set for automatic
recharge
Today: 121
Daily average: 175
Remaining: 736
*
Efficiency mode
Max. days between rech...
Auxiliary control
Special features
FIG. 21
Effieciency mode
Auxiliary control
Special features
Max. days between
recharges
FIG. 22
One second after being highlighted, the viewing box
expands (See Figure 22) to show the entire message.
After three seconds the view resets (Figure 21).
The softener status screens described in the previous
section will not be displayed in a rolling sequence when
one of the following items is displayed:
=
Recharge status
(Displayed during recharges,
showing valve position and time remaining)
=
Add salt
or
Out of salt
(See Page 26)
=
Current time
setting screen instead of status
screens indicates time has been lost, perhaps after
a long power loss. Set the time (See Page 16).
=
Service reminder
(See Page 24)
=
Error detected
(Contact your dealer for service)
FLASHING DISPLAY
The softener’s display will flash on and off when one or
more of the following conditions occurs:
=
Salt needs to be added
=
Time needs to be set (Time has been lost)
=
Service is overdue (Service reminder)
=
Error condition
The flashing will stop after any key is pressed.
However, it will start again at Midnight if the underlying
condition (e.g. low salt level) has not been addressed.
LONG DISPLAY SCREEN MESSAGES
Most messages in the softener’s display screens are
short enough to be shown as a single line. Longer
messages will be truncated (See Figure 21 for an
example) until you highlight them.
OTHER MESSAGES, ALERTS & REMINDERS
Programming the Water Softener
