Procedure
10.
Chose set up procedure (Teach) and confirm with OK.
Teach
11.
Start the set up procedure (Teach) and confirm with OK.
Teach
ok?
12.
The set up procedure starts automatically after 10 seconds (or directyl by moving the joystick
, without OK). The drive beeps during the set up process.
Following learning trip is made:
Inverse: First, the closed position is searched at creep spped.
Creep spped in opening direction
Creep speed in closing direction
Teach1
x E10
Teach2
x E10
13.
The following message is displayed at the end of the learning trip:
Done !
x E11
14.
Display should now show the following:
E11 shows that the set up process is not yet finished.
>##<
E11
15.
Use the opening command to open and close the door leaf. This opens and closes at normal
speed (withouth obstacle detection).
Note:
Door leaf must not be obstructed.
Display should now show the following:
The set up process is now complete.
>##<
E11
Note:
A new set up process is necessary if:
the spring tension was changed
the leaf weight was changed
the linkage type was changed
the opening angle Ao was changed
the Teach was obstructed before 20° opening angle
the axis distance (dAxis) was changed
the parameter inverse was changed.
9
Summary of Contents for ETS Series
