Chapter I Page 8
ELECTRONIC 12/24 V DC CONTROL PANEL ADJUSTS
(Recommended for experts only)
FLUSH WATER FLOW ADJUST
•
Turn on the system while pressing the LAVADO/FRESH FLUSH button, the blue
LED on the control unit will turn on.
•
After this, each key press of the
▲
button will increase the pump’s speed in one
unit, and, every key press of the
▼
button will decrease it in the same way.
•
Once reached the wanted flush water flow press the Stop button, the red led will
get on, after releasing it the led will flash, this means the water flow has been
adjusted.
•
Switch off the system and switch it on again to return to its normal functioning
HOUR METER READING
•
Switch the system on while pressing the Stop button in the control panel.
•
Both green and red LEDS will flash a few times.
•
Each green flash is equivalent to 400 working hours and each red flash is
equivalent to 25 working hours. The total reading of working hours of the system
is given by the sum of all green and red flashes.
•
The maximum count will be 8 green flashes and 3 red flashes, which makes a
3275 hour reading, from that moment the hour meter gets self-restarted, starting a
new reading cycle.
•
The green led will flash 5 times when the system reaches 2.000 hours working,
which means the pump’s maintenance must be performed.
•
Switch off the system and switch it on again to return it to it’s normal functioning.
12V DC FALL DOWN ALARM.
•
The system will stop if the power sources voltage drops below 10 V DC, if this
happens the RED led will start blinking at a 3 times per second rate.
