4
How the Automatic Sediment Filter Works
The EcoPure Automatic Sediment Filter is designed to
be plumbed into a home’s incoming water supply pipe,
where it will capture particles of sediment from the
water and periodically flush them down the drain.
Specifications
Rated Service Flow Rate
35 gpm (132 lpm)
Water Pressure Limits (minimum / maximum)
30 - 100 psi (207 - 689 kPa)
Water Temperature Limits (minimum / maximum)
40 - 120 °F (5 - 49 °C)
Inlet - Outlet
1” NPT
INSTALLATION LOCATION
To filter sediments from all household water, install the
Automatic Sediment Filter on the household’s main
incoming water pipe. The Automatic Sediment Filter
Pressure
Tank
City Water Supply
Well Water Supply
Well
Pump
OR
Automatic
Sediment
Filter
Untreated Water to
Outside Faucets
Cold Water
to House
should be installed upstream from the water softener
(if any), the water heater and all inside faucets. See
diagram below.
FIG. 3
Water
Softener
Water
Heater
Hot Water
to House
Planning the Installation
The unit has an electronic control that counts down the
days until the next automatic flush of collected sedi-
ment particles. The number of days is programmable.
The electronic controller runs on a 9 volt battery. The
controller will indicate when the battery needs to be
replaced. An optional AC power adaptor (P/N
7302835) may also be purchased to eliminate the
need for batteries.
Three sizes of filter mesh are available. A 60 micron fil-
ter is included with the ASF unit, and optional 100 or
150 micron filters can also be purchased (see spare
parts list at the end of this manual).
NOTE:
This product is designed to reduce sand,
grit, debris, pipe scale and other loose matter. On
water supplies that contain sticky sediment includ-
ing mud, silt and clay, you may have to remove
the sump and clean the screen frequently.
